M150XN07 V 1 PDF

Find great deals for Mxn07 V.1 AUO 15″ LCD Display. Shop with confidence on eBay!. MXNV1 Datasheet PDF Download – LCD MODULE, MXNV1 data sheet. : Brand New AUO 15″ LCD Panel MXN07 V1, High Resolution x, Aspect Ratio , Brightness Nits, CCFL Backlight, with Inverter.

Author: Taugar Akinolkree
Country: Albania
Language: English (Spanish)
Genre: Education
Published (Last): 4 December 2004
Pages: 25
PDF File Size: 18.67 Mb
ePub File Size: 7.8 Mb
ISBN: 920-8-71607-429-9
Downloads: 47939
Price: Free* [*Free Regsitration Required]
Uploader: Gagor

AU Optronics MXN07 V1 Overview –

Note 3 Crosstalk at 60Hz 1. Definition of Response time: The printed circuit board will be made from material rated V1 or better.

Item Unit Conditions Min. Refer to figure as below. Refer to figure as below. OVibration, Shock, and Drop O No Reproduction and Redistribution Allowed.

No Reproduction and Redistribution Allowed. Likewise the module shall not sustain any damage after vibration and shock test.

Lamp units need voltage minimum for m15x0n07 Note 4: CCFL inverter should be able to give out a power that has a generating capacity of over voltage.

The actual UL flammability rating will be printed on the printed circuit board. Be sure to turn off power supply when inserting or disconnecting from input connector.

  AMBROSIO ALFINGER PDF

Long contact with water may cause discoloration or spots. Do not open nor modify the Module Assembly. CCFL life time will drop dramatically if exceeding 8. Note 2 Luminance uniformity 1.

Note 3 Crosstalk at 60Hz 1. Please follow local ordinances or regulations for disposal. Do not press the reflector sheet at the back of the module to any directions. After temperature cycling, the unit is placed in normal room ambient for at least 4 hours before powering on.

Original M150XN07 V.1 15″ LCD DISPLAY PANEL M150XN07 V1 M150XN07V.1

Brightness uniformity of these 9 points is defined as below: The actual UL flammability rating will be printed on the printed circuit board. Brightness is measured at the center m150nx07 of brightness value with all pixels displaying white. Otherwise the TFT Module may be damaged. After temperature cycling, the unit is placed in normal room ambient for at least 4 hours before powering on.

Signal 0V Lamp On 0V ms 0 min.

M150XN07 V1

In case if a Module has to be put back into the packing container slot m150xn077 once it was taken out from the container, do not press the center of the CCFL Reflector edge. If toxic materials are used, they will be reviewed and approved by the responsible AUO Toxicologist.

  CA358E DATASHEET PDF

This module does not contain an inverter card for backlight. Long contact with water may cause discoloration or spots. If toxic materials are used, they will be reviewed and approved by the responsible AUO Toxicologist. Instead, press at the far ends of m50xn07 CFL Reflector edge softly. The average failure rate of the display module from 1, hours until 10, hours will not exceed 0.

Likewise the module shall not sustain any damage after vibration and shock test.

Mxn07 V.1 AUO 15″ LCD Display | eBay

CCFL m150xn077 should be able to give out a power that has a generating capacity of over voltage. The average failure rate of the display module from 1, hours until 10, hours will not exceed 0.

Only as for maximum white luminance, following criteria is applicable. Brightness uniformity of these 9 points is defined as below: